🟡 sched/rt: Skip currently executing CPU in rto_next_cpu() (Linux Linux)

Description

In the Linux kernel, the following vulnerability has been resolved: sched/rt: Skip currently executing CPU in rto_next_cpu() CPU0 becomes overloaded when hosting a CPU-bound RT task, a non-CPU-bound RT task, and a CFS task stuck in kernel space. When other CPUs switch from RT to non-RT tasks, RT load balancing (LB) is triggered; with HAVE_RT_PUSH_IPI enabled, they send IPIs to CPU0 to drive the execution of rto_push_irq_work_func. During push_rt_task on CPU0, if next_task->prio < rq->donor->prio, resched_curr() sets NEED_RESCHED and after the push operation completes, CPU0 calls rto_next_cpu(). Since only CPU0 is overloaded in this scenario, rto_next_cpu() should ideally return -1 (no further IPI needed). However, multiple CPUs invoking tell_cpu_to_push() during LB increments rd->rto_loop_next. Even when rd->rto_cpu is set to -1, the mismatch between rd->rto_loop and rd->rto_loop_next forces rto_next_cpu() to restart its search from -1. With CPU0 remaining overloaded (satisfying rt_nr_migratory && rt_nr_total > 1), it gets reselected, causing CPU0 to queue irq_work to itself and send self-IPIs repeatedly. As long as CPU0 stays overloaded and other CPUs run pull_rt_tasks(), it falls into an infinite self-IPI loop, which triggers a CPU hardlockup due to continuous self-interrupts. The trigging scenario is as follows: cpu0 cpu1 cpu2 pull_rt_task tell_cpu_to_push <------------irq_work_queue_on rto_push_irq_work_func push_rt_task resched_curr(rq) pull_rt_task rto_next_cpu tell_cpu_to_push <-------------------------- atomic_inc(rto_loop_next) rd->rto_loop != next rto_next_cpu irq_work_queue_on rto_push_irq_work_func Fix redundant self-IPI by filtering the initiating CPU in rto_next_cpu(). This solution has been verified to effectively eliminate spurious self-IPIs and prevent CPU hardlockup scenarios.